Common fault treatment of Concrete Batching Plant conveyor
Common fault treatment of Concrete Batching Plant conveyor
1, Belt Deviation The reason:
- (1). Adhesive mud on the roller, so that the friction between the belt and the roller is not uniform.
- (2). Too little weight or belt too loose.
- (3) material blanking is not in the middle belt.
- (4). Belt elongation uneven.
deal with:
- (1). Remove the silt on the roller.
- (2). Increase the weight or by adjusting the screw to tighten the belt.
- (3). The material falls in the middle of the belt.
- (4). Adjust the belt conveyor.
2, care stick does not turn or abnormal sound.
Cause: Roller bearing is damaged.
Remedy: Replace the bearings.
3, trailer wear wear.
Reason: use a long time.
Remedy: Replace idler.
4, scraping sand board wear.
Reason: use a long time.
Remedy: Replace the wiper plate.
5, belt tear.
Cause: Mechanical failure.
Treatment: Adhesive repair is available for minor tears.
6, belt elongation.
Reason: long-term bear tension.
Treatment: cut short belt, and then curing adhesive curing.
7, then hopper rubber flange wear.
Reason: use a long time.
Remedy: Replace the rubber ribs.
